Category Archives: User Interfaces

Qt 5.1 on the blackberry playbook

I purchased a Blackberry Playbook a few months to experiment with Qt. At this moment, I am fiddling with Qt5.1. The documentation that helped me along can be found on: http://qt-project.org/wiki/Building-Qt5-for-the-Playbook http://qt-project.org/wiki/Building_and_Deploying_Qt_Applications_to_the_Playbook   https://github.com/preet/scratch/wiki/Qt-5.1-on-the-Playbook I hope these URL’s are also … Continue reading

Posted in Post QNX, Post Webkit, Qt, User Interfaces | Tagged , , , , , , | Leave a comment

Qt on Blackberry Playbook, building qnx-qt-mobility on Windows

Building qnx-qt-mobility on Windows is a straight forward job. Make sure that your Qt is installed where you want it (see previous post). Then bear in mind the following: Set the environment variables TMP and TEMP to c:\Temp. Make sure … Continue reading

Posted in Post QNX, User Interfaces | Tagged , , , , , | 1 Comment

Qt on Blackberry Playbook, step 2 building for Windows

While using my brand new Qt build, I ran into some issue while adding a number of modules. It seemed that qmake was pointing towards the folder where it was build. After a bit of reading, i found out that … Continue reading

Posted in User Interfaces | Tagged , , , , | Leave a comment

Blackberry playbook, my first steps

I was looking for a Blackberry Playbook because it runs qnx and I needed a Qt test platform 🙂 So, I got one from Ebay and started to read the qt-project wiki. This wiki provides all information that is required … Continue reading

Posted in Post QNX, User Interfaces | Tagged , , , , , , , , , , , | Leave a comment

Ordered the Raspberry Pi

A few month ago, the Raspberry Pi was announced. On the 29th of februari, a huge amount of geeks, enthusiast, computer programmers were able to bring down 3 websites. RS-Components, Farnell and Raspberry Pi‘s website were not able to process the registrations … Continue reading

Posted in domotica, Post Embedded, Uncategorized, User Interfaces | Tagged , , , , , , , | Leave a comment

Domotica using a NAS, a CA42, a Remeha heater and HTML5 part 4, the result.

It has been a little while ago but I made some progress and here is the result… A web interface showing information obtained from the Remeha Avanta heating. This is how it works: My Synology DS210J runs an application named … Continue reading

Posted in communication, domotica, Uncategorized, User Interfaces | Tagged , , , , , , , , , , | 3 Comments

Domotica using a NAS, a CA42, a Remeha heater and HTML5 part 2

I lost some time getting the CA42 to work. The cable I am using carries vendorID 0421 and productID 0802. A lot of suggestions on the web suggested to use the usbserial driver. I had to pass the vendor and … Continue reading

Posted in communication, domotica, User Interfaces | Tagged , , , , , , , , , , | 1 Comment