Tag Archives: ATS

Blackberry playbook, my first steps

I was looking for a Blackberry Playbook because it runs qnx and I needed a Qt test platform 🙂 So, I got one from Ebay and started to read the qt-project wiki. This wiki provides all information that is required … Continue reading

Posted in Post QNX, User Interfaces | Tagged , , , , , , , , , , , | Leave a comment

Domotica using a NAS, a CA42, a Remeha heater and HTML5 part 4, the result.

It has been a little while ago but I made some progress and here is the result… A web interface showing information obtained from the Remeha Avanta heating. This is how it works: My Synology DS210J runs an application named … Continue reading

Posted in communication, domotica, Uncategorized, User Interfaces | Tagged , , , , , , , , , , | 3 Comments

Domotica using a NAS, a CA42, a Remeha heater and HTML5 part 3

Yesterday, I took some time and installed a serial sniffer on my laptop and peeked at the commununication between the Avanta P1 boiler and my laptop. I ran the Recom software and requested the boilers identity. The following command is … Continue reading

Posted in communication, domotica | Tagged , , , , , , , , , , , , , , , , , , , , | 1 Comment

Domotica using a NAS, a CA42, a Remeha heater and HTML5 part 2

I lost some time getting the CA42 to work. The cable I am using carries vendorID 0421 and productID 0802. A lot of suggestions on the web suggested to use the usbserial driver. I had to pass the vendor and … Continue reading

Posted in communication, domotica, User Interfaces | Tagged , , , , , , , , , , | 1 Comment

Domotica using a NAS, a CA42, a Remeha heater and HTML5

I want to have something to measure and show my energy consumption. A number of power companies in the Netherlands are offering gadgets for this purpose. Eneco offers Toon, Nuon offers the E-Manager and Essent offers the E-Thermostat. But there is a … Continue reading

Posted in domotica, Uncategorized, User Interfaces | Tagged , , , | 2 Comments

SCADA software has gotten out of control

SCADA software has gotten out of control, Ignition runs on Windows, Mac and Linux. 100% Cross Platform!

Continue reading

Posted in Post OPC, Post Scada | Tagged , , , , , , , , , , , , , | 1 Comment

Openbricks, an industrial grade Embedded Linux Framework

You really might want to take a look at http://www.openbricks.org If you are in the process of cooking your own linux distro for an ARM platform like the IGEPv2. I am using it to get Geexbox up and running on … Continue reading

Posted in Post Embedded | Tagged , , , , , , , , , | Leave a comment